honda — Programmed Fuel Injection

BF135A•BF150A 3. Knock sensor signal line short circuit check -1. Check for the continuity between the test harness A-15 terminal and the engine ground. • ECT Sensor 2 Troubleshooting MIL blinks 24 times 1. Symptom reproduction test -1. Reset the ECM. -2. Turn the ignition switch OFF and connect the test har- ness. Hold the sensor connector connected. -3. Turn the ignition switch ON. -4. Measure the voltage between the test harness B-12 terminal (+) and the A-2 terminal (–). A-15 A-2 B-12 Is there the continuity? YES – Repair short in the wire between the ECM and the spool solenoid valve. NO – Substitute a known-good ECM and recheck. Is the voltage 0.08 – 4.99V?

YES – Temporary failure (Disappeared) NO – Perform "2. ECT sensor 2 signal line open cir- cuit check". 2. ECT sensor 2 signal line open circuit check -1. Turn the ignition switch OFF. Disconnect the 2P con- nector from the ECT sensor 2. -2. Turn the ignition switch ON. -3. Measure the voltage between the No. 2 (Red/Black) terminal of the ECT sensor 2 harness side 2P con- nector and the engine ground. ECT SENSOR 2 HARNESS SIDE 2P CONNECTOR TOH1 (RED/BLACK) VIEWED FROM THE TERMINAL SIDE Is the voltage 4.75 – 5.25V? YES – Perform "3. ECT sensor 2 ground line short circuit check". NO – Repair open in the wire between the ECT sensor 2 and the ECM. 5-84