BF135A•BF150A 3. ECT sensor 2 ground line short circuit check -1. Turn the ignition switch OFF. Disconnect the ECT sen- sor 2 connector and the ECM connector B. -2. Check for the continuity between the No. 2 (Red/ Black) terminal of the ECT sensor 2 harness side 2P connector and the body ground. 5. ECT sensor 2 check -1. Turn the ignition switch OFF and disconnect the 2P connector of the ECT sensor 2 . -2. Measure the resistance between the No. 1 and the No. 2 terminals of the ECT sensor 2 side 2P connector. ECT SENSOR 2 SIDE 2P CONNECTOR ECT SENSOR 2 HARNESS SIDE 2P CONNECTOR TOH1 (RED/BLACK) VIEWED FROM THE TERMINAL SIDE VIEWED FROM THE TERMINAL SIDE Is there the continuity?
YES – Repair short in the wire between the ECT sensor 2 and the engine ground. NO – Perform “4. ECT sensor 2 ground line open circuit check”. RESISTANCE 4. ECT sensor 2 ground line open circuit check -1. Reset the ECM connector B. -2. Check for the continuity between the No. 1 (Green/ Red) terminal of the ECT sensor 2 harness side 2P connector and the body ground. ENGINE COOLANT TEMPERATURE ECT SENSOR 2 HARNESS SIDE 2P CONNECTOR Is there the resistance corresponding to the engine coolant temperature? YES – Substitute a known-good ECM and recheck. NO – Replace the ECT sensor 2. SG2 (GREEN/RED) VIEWED FROM THE TERMINAL SIDE Is there the continuity? YES – Perform "5. ECT sensor 2 check".
NO – Repair open in the wire between the ECT sensor 2 and the engine ground. 5-85