honda — Programmed Fuel Injection

BF135A•BF150A • ECT Sensor 3 Troubleshooting 3. ECT sensor 3 signal line short circuit check -1. Turn the ignition switch OFF. Disconnect the ECT sen- sor 3 connector and the ECM connector B. -2. Check for the continuity between the No. 2 (Red) ter- minal of the ECT sensor 3 harness side 2P connector and the body ground. MIL blinks 25 times 1. Symptom reproduction test -1. Reset the ECM. -2. Turn the ignition switch OFF and connect the test har- ness. Hold the sensor connector connected. -3. Turn the ignition switch ON. -4. Measure the voltage between the test harness A-16 terminal (+) and the A-2 terminal (–).

ECT SENSOR 3 HARNESS SIDE 2P CONNECTOR TOH2 (RED) A-2 VIEWED FROM THE TERMINAL SIDE A-16 Is there the continuity? YES – Repair short in the wire between the ECT sensor 3 and the engine ground. NO – Perform "4. ECT sensor 3 ground line open circuit check". Is the voltage 0.08 – 4.99V? YES – Temporary failure (Disappeared) NO – Perform "2. ECT sensor 3 signal line open cir- cuit check". 4. ECT sensor 3 ground line open circuit check -1. Connect the ECM connector B. -2. Check for the continuity between the No. 1 (Green/ Red) terminal of the ECT sensor 3 harness side 2P connector and the body ground. 2. ECT sensor 3 signal line open circuit check -1. Turn the ignition switch OFF.

Disconnect the 2P con- nector from the ECT sensor 3. -2. Turn the ignition switch ON. -3. Measure the voltage between the No. 2 (Red) terminal of the ECT sensor 3 harness side 2P connector and the engine ground. ECT SENSOR 3 HARNESS SIDE 2P CONNECTOR ECT SENSOR 3 HARNESS SIDE 2P CONNECTOR SG2 (GREEN/RED) TOH2 (RED) VIEWED FROM THE TERMINAL SIDE VIEWED FROM THE TERMINAL SIDE Is there the continuity? YES – Perform "5. ECT sensor 3 check". NO – Repair open in the wire between the ECT sensor 3 and the engine ground. Is the voltage 4.75 – 5.25V? YES – Perform "3. ECT sensor 3 signal line short cir- cuit check". NO – Repair open in the wire between the ECT sensor 3 and the ECM. 5-86