BF135A•BF150A 5. ECT sensor 3 check -1. Turn the ignition switch OFF and disconnect the ECT sensor 3 2P connector. -2. Measure the resistance between the No.1 and No.2 terminals of the ECT sensor 3 side 2P connector. EOP switch (High Pressure Side) Troubleshooting MIL blinks 26 times 1. Symptom reproduction test -1. Reset the ECM. -2. Turn the ignition switch OFF and connect the test har- ness. Hold the sensor connector connected. -3. Turn the ignition switch ON. -4. Measure the voltage between the test harness A-17 terminal (+) and A-2 terminal (–). ECT SENSOR 3 SIDE 2P CONNECTOR A-2 VIEWED FROM THE TERMINAL SIDE A-17 RESISTANCE Is the voltage 0V (OFF signal)?
YES – Temporary failure (Disappeared) NO – Perform "2. EOP switch signal line open cir- cuit check". 2. EOP switch signal line open circuit check -1. Turn the ignition switch OFF and disconnect the EOP switch 2P connector. -2. Turn the ignition switch ON. Measure the voltage between the No.1 (Yellow/Red) terminal of the EOP switch harness side 2P connector and the body ground. ENGINE COOLANT TEMPERATURE Is there the resistance corresponding to the engine coolant temperature? YES – Substitute a known-good ECM and recheck. NO – Replace the ECT sensor 3. EOP SWITCH HARNESS SIDE 2P CONNECTOR OPSH (YELLOW/RED) VIEWED FROM THE TERMINAL SIDE Is there the battery voltage?
YES – Perform “3.EOP switch signal line short circuit check”. NO – Repair open in the wire between the EOP switch and the ECM. 5-87