honda — Programmed Fuel Injection

BF135A•BF150A 3. EOP switch signal line short circuit check -1. Turn the ignition switch OFF. Disconnect the EOP switch 2P connector and the ECM connector A. -2. Check for the continuity between the No.1 (Yellow/ Red) terminal of the EOP switch harness side 2P con- nector and the body ground. 5. EOP switch check -1. Turn the ignition switch OFF and connect each con- nector. -2. Turn the ignition switch ON and measure the voltage between the test harness A-17 terminal (+) and the A- 2 terminal. EOP SWITCH HARNESS SIDE 2P CONNECTOR A-2 OPSHH (YELLOW/RED) A-17 Is the voltage 0V (switch OFF)? YES – Substitute a known-good ECM and recheck. NO – Replace the EOP switch (high pressure side).

VIEWED FROM THE TERMINAL SIDE Is there the continuity? YES – Repair short in the wire between the EOP switch and the ECM. NO – Perform “4. EOP switch ground line open cir- cuit check”. 4. EOP switch ground line open circuit check -1. Check for the continuity between the No.2 (Green/ Red) terminal of the EOP switch harness side 2P con- nector and the body ground. EOP SWITCH HARNESS SIDE 2P CONNECTOR SG2 (GREEN/RED) VIEWED FROM THE TERMINAL SIDE Is there the continuity? YES – Perform "5. EOP switch check". NO – Repair open in the wire between the EOP switch and the ECM. 5-88