BF135A•BF150A • ECT Sensor 4 Troubleshooting 3. ECT sensor 4 signal line short circuit check -1. Turn the ignition switch OFF. Disconnect the ECT sen- sor 4 connector and the ECM connector B. -2. Check for the continuity between the No.2 (Red/ Green) terminal of the ECT sensor 4 harness side 2P connector and the body ground. MIL blinks 27 times 1. Symptom reproduction test -1. Reset the ECM. -2. Turn the ignition switch OFF and connect the test har- ness. Hold the sensor connector connected. -3. Turn the ignition switch ON. -4. Measure the voltage between the test harness A-6 ter- minal (+) and the A-2 terminal (–).
ECT SENSOR 4 HARNESS SIDE 2P CONNECTOR TOH3 (RED/GREEN) A-2 A-6 VIEWED FROM THE TERMINAL SIDE Is there the continuity? YES – Repair short in the wire between the ECT sensor 4 and the engine ground. NO – Perform “4. ECT sensor 4 ground line open circuit check”. Is the voltage 0.08 – 4.99V? YES – Temporary failure (Disappeared) NO – Perform "2. ECT sensor 4 signal line open cir- cuit check". 2. ECT sensor 4 signal line open circuit check -1. Turn the ignition switch OFF and disconnect the 2P connector from the ECT sensor 4. -2. Turn the ignition switch ON. -3. Measure the voltage between the No.2 (Red/Green) terminal of the ECT sensor 4 harness side 2P con- nector and the engine ground. 4.
ECT sensor 4 ground line open circuit check -1. Connect the ECM connector B. -2. Check for the continuity between the No.1 (Green/ Red) terminal of the ECT sensor 4 harness side 2P connector and the body ground. ECT SENSOR 4 HARNESS SIDE 2P CONNECTOR ECT SENSOR 4 HARNESS SIDE 2P CONNECTOR SG2 (GREEN/RED) TOH3 (RED/GREEN) VIEWED FROM THE TERMINAL SIDE VIEWED FROM THE TERMINAL SIDE Is there the continuity? YES – Perform "5. ECT sensor 4 check". NO – Repair open in the wire between the ECT sensor 4 and the engine ground. Is the voltage 4.75 – 5.25V? YES – Perform "3. ECT sensor 4 signal line short cir- cuit check". NO – Repair open in the wire between the ECT sensor 4 and the ECM. 5-89