honda — Programmed Fuel Injection

BF135A•BF150A 5. ECT sensor 4 check -1. Turn the ignition switch OFF and disconnect the ECT sensor 4 2P connector. -2. Measure the voltage between the No.1 and No.2 ter- minals of the ECT sensor 4 side 2P connector. • A/F Sensor Heater Troubleshooting MIL blinks 41 times 1. Symptom reproduction test -1. Reset the ECM. -2. Start the engine and run it at 3,000 rpm for 5 minutes or more to warm up. -3. Check the MIL. ECT SENSOR 4 SIDE 2P CONNECTOR Does the MIL come ON? YES – Perform "2. A/F relay check". NO – Temporary failure (Disappeared) 2. A/F relay check -1. Turn the ignition switch OFF and connect the test har- ness. Hold the sensor connector connected. -2.

Disconnect the A/F sensor 4P connector. -3. Turn the ignition switch ON. Measure the voltage between the test harness C-4 terminal and the engine ground. VIEWED FROM THE TERMINAL SIDE RESISTANCE C-4 ENGINE COOLANT TEMPERATURE Is there the resistance corresponding to the engine coolant temperature? YES – Substitute a known-good ECM and recheck. NO – Replace the ECT sensor 4. Is there the battery voltage? YES – Perform "4. A/F heater check". NO – Check the A/F relay and replace if necessary. If it is normal, go to the step 4. -4. Turn the ignition switch OFF and disconnect the A/F relay 4P connector. -5.

Measure the voltage between the No.1 (White/ Green) terminal of the A/F relay harness side 4P connector and the engine ground. Note that the battery voltage is constantly applied to the White/Green terminal. Take care not to short-cir- cuit the terminal. A/F RELAY HARNESS SIDE 4P CONNECTOR +B (WHITE/GREEN) VIEWED FROM THE TERMINAL SIDE 5-90