BF135A•BF150A 4. A/F heater check -1. Turn the ignition witch OFF and disconnect the A/F sensor 4P connector. -2. Measure the resistance between the No.3 (Black) and No.4 (Black) terminals of the A/F sensor’s sensor side 4P connector. Is there the battery voltage? YES – Go to the step 6. NO – Blown No.1 (30A) fuse, or repair open in the wire between the A/F relay and the No.1 (10A) fuse. -6. Turn the ignition switch ON. Measure the voltage between the No.2 (Yellow/Red) terminal of the A/F relay harness side 4P connector and the engine ground. A/F SENSOR SIDE 4P CONNECTOR A/F RELAY HARNESS SIDE 4P CONNECTOR AFHT (BLACK) AFHT+ (BLACK) IGP (YELLOW/RED) VIEWED FROM THE TERMINAL SIDE ?
YES – Perform “5. Heater line short circuit check”. NO – Replace the A/F sensor. Is the resistance 2 – 3 VIEWED FROM THE TERMINAL SIDE 5. Heater line short circuit check -1. Turn the ignition switch OFF and disconnect the ECM connector C. -2. Check for the continuity between the test harness C-3 terminal and the engine ground, and between the C-4 terminal and the engine ground. Is there the battery voltage? YES – Perform "3. A/F relay drive line check". NO – Blown No.5 (10A) fuse, or repair open in the wire between the A/F relay and the No.5 fuse. 3. A/F relay drive line check -1. Turn the ignition switch OFF and connect the A/F relay connector. -2. Disconnect the ECM connector A. -3.
Turn the ignition switch ON and measure the voltage between the test harness A-25 and the engine ground. C-3 C-4 Is there the continuity? YES – Repair short in the wire between the A/F sen- sor and the ECM. NO – Perform “6. Heater line open circuit check”. A-25 Is there the battery voltage? YES – Substitute a known-good ECM and recheck. NO – Repair open in the A/F relay and the ECM. 5-91