honda — Programmed Fuel Injection

BF135A•BF150A 6. Heater line open circuit check -1. Connect the No.3 (Black/White) and the No.4 (White) terminals of the A/F sensor harness side 4P connector respectively to the engine ground with the jumper wires. -2. Check for the continuity between the test harness C-3 terminal and the engine ground, and between the C-4 terminal and the engine ground. • A/F Sensor Troubleshooting MIL blinks 48 times 1. Symptom reproduction test -1. Reset the ECM. -2. Start the engine and let it warm up by running the engine at 3,000 rpm for 5 minutes or more under no load. Run the engine at idling for an additional one minute under no load. -3. Check the MIL. C-3 C-4 Does the MIL come ON?

YES – Perform "2. A/F sensor line open circuit check". NO – Temporary failure (Disappeared) 2. A/F sensor line open circuit check -1. Turn the ignition switch OFF. Disconnect the A/F sen- sor connector and the ECM connector A. -2. Connect the No.1 (White/Black) terminal of the A/F sensor harness side 4P connector to the engine ground to short using a jumper wire. -3. Check for the continuity between the test harness A-4 terminal and the engine ground. Is there the continuity? YES – Perform "7. Sensor line short circuit check". NO – Repair open in the wire between the A/F sen- sor and the ECM. 7. Sensor line short circuit check -1. Disconnect the ECM connector B. -2.

Disconnect the A/F sensor 4P connector. -3. Check for the continuity between the test harness C-3 terminal and the respective terminals of A-4 and A-14 terminals, and between the C-4 terminal and the respective terminals of A-4 and A-14 terminals. A-4 A-4 C-3 Is there the continuity? YES – Go to the step 4. NO – Repair open in the wire between the A/F sen- sor and the ECM. C-4 A-14 Is there the continuity? YES – Repair short in the wire between the A/F sen- sor and the ECM. NO – Replace the A/F sensor and recheck. If it is still abnormal, substitute a known-good ECM and recheck. -4.

Connect the No.2 (Black/Yellow) terminal of the A/F sensor harness side 4P connector to the engine ground to short using a jumper wire. -5. Check for continuity between the test harness A-14 ter- minal and the engine ground. A-14 Is there the continuity? YES – Perform "3. A/F sensor line short circuit check". NO – Repair open in the wire between the A/F sen- sor and the ECM. 5-92