honda — Programmed Fuel Injection

BF135A•BF150A 3. A/F sensor line short circuit check -1. Turn the ignition switch OFF. Disconnect the A/F sen- sor connector and the ECM connector A. -2. Check for the continuity between the test harness A-4 terminal and the engine ground. 8. IDLE CONTROL SYSTEM • Troubleshooting When the MIL does not come ON but an engine failure of either of the following symptoms occurs at the engine start or during idling, inspect the system(s) and part(s) in the numbered sequence. A-4 • Hard to start 1. Vacuum line 2. IAC valve (P. 5-95) Is there the continuity? YES – Repair short in the wire between the A/F sen- sor and the ECM. NO – Go to the step 3. • Engine starts but stalls soon. 1.

Idle adjusting screw (P. 5-94) 2. IAC valve (P. 5-95) 3. Vacuum line -3. Check for the continuity between the test harness A-14 terminal and the engine ground. • Engine speed is higher than the specified idle speed after warming up. 1. Vacuum line 2. IAC valve (P. 5-95) 3. Idle adjusting screw (P. 5-94) A-14 • Engine speed is higher than the specified trolling speed after warming up. 1. Neutral switch (P. 17-13) 2. Vacuum line 3. Idle adjusting screw (P. 5-94) 4. IAC valve (P. 5-95) Is there the continuity? YES – Repair short in the wire between the A/F sen- sor and the ECM. NO – Replace the A/F sensor and recheck. If there is any abnormality, substitute a known-good ECM and recheck.

• Engine speed is lower than the specified idling or trolling speed after warming up. 1. IAC valve (P. 5-95) 2. Idle adjusting screw (P. 5-94) 3. Vacuum line • Engine speed is not stable during idling and trolling. 1. IAC valve (P. 5-95) 2. Idle adjusting screw (P. 5-94) 3. Vacuum line 4. Neutral switch (P. 17-13) 5-93