honda — Programmed Fuel Injection

BF135A•BF150A • Idle Adjusting Screw Adjustment 6) Adjust the idle speed by turning the adjusting screw. If adjustment cannot be made, check each vacuum tube for disconnection and collapse, then check and clean the throttle body (P. 5-95). Check the following before adjustment. Idle speed inspection (P. 3-22) Spark plug (P. 3-6) MIL is OFF. (If it is ON, troubleshoot according to the chart on P. 5-15 or 5-59.) ADJUSTING SCREW 1) Remove the propeller. Set the outboard motor in a test tank filled with water. Fill the tank with water above the gear case. 2) Connect the HDS tester (P. 5-13). If you do not have the HDS tester, connect a digital tachometer (P. 3-22).

3) Set the SCS mode using the HDS tester. If you do not have the HDS tester, disconnect the red 4P connector and connect (short-circuit) the SCS short connector to the DLC . (P. 5-57). 7) After adjustment, connect the IAC valve 2P connector and clear the DTC (P. 5-14) or reset the ECM (P. 5-57). 4) Start the engine and let it warm up with the gear in neutral. 8) Run the engine at idling for 5 minutes or more, then check the idle speed again. 5) Disconnect the IAC valve 2P connector and check the idle speed. 9) If the idle speed is out of the specification, repeat the procedure from step 5) through step 8). If the idle speed is still out of the specification, replace the IAC valve.

If the specified idle speed cannot be obtained yet, replace the ECM with a new one and recheck. 2P CONNECTOR 10)After adjustment, apply the paint (Nippon Paint Unipack #200 or equivalent) to the head of the adjust- ing screw. ADJUSTING SCREW IAC VALVE Apply paint here. 5-94 Specified idle speed 750 ± 50 min-1 (rpm) Specified idle speed 575 ± 30 min-1 (rpm)