BF135A•BF150A • Throttle Body Inspection/Cleaning 7) After cleaning, install the throttle rod and the silencer chamber (P. 5-135). 1) Remove the engine cover. 2) Remove the intake air silencer (P. 5-128). 3) Turn the throttle cam and check the throttle valve for smooth movement and the throttle valve shaft for play. 4) Check that there is no gap between the throttle shaft stopper and the throttle stop screw. The throttle stop screw cannot be adjusted. If it is faulty, replace the throttle body. 8) After assembly, check the idle speed and adjust if nec- essary (P. 5-94). • IAC Valve Replacement 1) Remove the engine cover.
THROTTLE STOP SCREW 2) Turn the ignition switch OFF and disconnect the IAC valve 2P connector. IAC VALVE 3) Remove the two 8 x 45 mm flange bolts and remove the IAC valve and IAC valve gasket. 2P CONNECTOR THROTTLE BODY 5) Check the throttle valve and bore for contamination. Clean if necessary. NOTICE IAC VALVE GASKET Do not spray the carburetor cleaner directly to the throttle body. Use the genuine Honda carburetor cleaner. Do not wipe the throttle valve where is coated with the molybdenum (i.e. both ends of the throttle valve). 3) Apply the engine oil to the new IAC valve gasket and install it.
6) Wipe the inner wall of the throttle bore and both ends of the throttle valve with a shop towel or equivalent material sprayed with the carburetor cleaner. 4) Install the IAC valve and tighten the 8 x 45 mm flange bolts securely. 5) Connect the IAC valve 2P connector securely. Clean. 6) Start the engine and let it warm up. Running the engine at idling, check the IAC valve for proper opera- tion (idle speed inspection; see P. 3-22). Coated with molybdenum 5-95