honda — Programmed Fuel Injection

BF135A•BF150A 14) Tighten the four 5 mm screw-washers securely. Install the connector bracket in the position shown and secure with the two 5 mm screw-washers. TORQUE: 3.4 N m (0.35 kgf m, 2.4 lbf ft) [1] 5 mm SCREW-WASHER (4) 3.4 N·m (0.35 kgf·m, 2.4 lbf·ft) [2] CONNECTOR BRACKET [3] PUMP COVER 15) Apply the engine to the new O-ring and install it on the strainer cover. [3] FUEL STRAINER SET [2] SEAL 16) Install the spring and the fuel strainer, and install the strainer cover. Install the fuel strainer in the direction shown. [1] STRAINER COVER 17) Tighten the 5 mm washer screws securely. TORQUE: 3.4 N m (0.35 kgf m, 2.4 lbf ft) [4] FILTER SPRING [5] O-RING Do not reuse.

[6] 5 mm SCREW (3) 18) Apply the engine oil to the new O-rings and install them on the collar. 6 x 25 [1] FUEL HOSE (HIGH PRESSURE SIDE) 19) Install the collar on the strainer cover. [2] O-RING (2) Do not reuse. 20) Set the fuel hose and secure it by tightening the 6 x 25 mm flange bolt. [5] COLLAR 21) Using a new sealing washer, tighten the service check bolt to the specified torque. TORQUE: 12 N m (1.2 kgf m, 9 lbf ft) [4] SERVICE CHECK BOLT [3] SEALING WASHER Do not reuse. 5-124