honda — Programmed Fuel Injection

BF135A•BF150A e. INSTALLATION 1) Install the vapor separator grommet and the collar on the fuel pump case. 2) Loosely tighten the vapor separator stay with the 8 mm washer and the 8 x 35 mm flange bolt. [1] VAPOR SEPARATOR STAY [3] VAPOR SEPARATOR GROMMET [2] COLLAR Tighten the 8 x 35 mm flange bolt, after installing the vapor separator assembly on the engine. 3) Connect the 4.5 x 55 mm fuel tube and secure it with the tube clip B8. 4) Connect the 3.5 x 420 mm drain tube to the vapor separator stay. 8 x 35 5) Set the vapor separator assembly on the engine, and loose- ly tighten it with the two 8 mm washers, two 8 x 35 mm flange bolts and the one 8 x 30 mm flange bolt.

[5] 4.5 x 55 mm FUEL TUBE [7] 3.5 x 420 mm DRAIN TUBE [4] 8 mm WASHER Align the projection of the vapor separator stay with the hole in the engine. [6] TUBE CLIP B8 (2) 6) Tighten the three 8 x 35 mm flange bolts and one 8 x 30 mm flange bolt to the specified torque. TORQUE: 26 N m (2.7 kgf m, 20 lbf ft) [8] VAPOR SEPARATOR ASSEMBLY [1] VAPOR SEPARATOR STAY [11] HOLE 8 x 30 8 x 35 (2) 8 x 35 (2) [9] 8 mm WASHER (2) [10]PROJECTION 5-125