honda — Programmed Fuel Injection

BF135A•BF150A 7) Connect the 7.3 x 350 mm water tube to the cylinder block and secure it with the tube clip. [1] TUBE CLIP [2] 7.3 x 350 mm WATER TUBE 8) Connect the fuel tube B to the vapor separator and secure it with the tube clip B12. [1] TUBE CLIP B12 [2] FUEL TUBE B 9) Connect the pressure regulator return hose to the vapor separator, and secure it with the tube clamp D10.5. [1] PRESSURE REGULATOR RETURN HOSE [3] VAPOR SEPARATOR [2] AIR VENT TUBE 10) Connect the air vent tube to the vapor separator. [4] TUBE CLAMP D10.5 11) Apply the engine oil to the new O-ring and install it on the joint pipe. [1] JOINT PIPE 12) Set the joint pipe in the fuel tube and install the fuel hose.

13) Tighten the 6 x 25 mm flange bolt to the specified torque. [3] FUEL HOSE (HIGH PRES- SURE SIDE [2] O-RING (2) 6 x 25 Do not reuse. 5-126