honda — Programmed Fuel Injection

BF135A•BF150A 12. SILENCER CASE/THROTTLE BODY/INTAKE MANIFOLD a. SILENCER CASE REMOVAL 1) Remove the engine cover. 2) Disconnect the IAT sensor 2P connector and remove the harness band clip from the silencer case. 3) Loosen the air flow tube clamp. 4) Disconnect the crankcase breather tube from the silencer case. [1] SILENCER CASE 5) Remove the three 6 x 25 mm flange bolts and the three 6 mm washers. Remove the silencer case. 6 x 25 (3) [2] 6 mm WASHER (3) • SILENCER CASE DISASSEMBLY/ASSEMBLY [1] SENSOR GROMMET [2] SILENCER CASE [3] SILENCER DUCT GROMMET ASSEMBLY: Install in the direction shown.

[4] COLLAR (3) [10] IAT SENSOR [5] GROMMET (3) [9] AIR FLOW TUBE [6] AIR FLOW TUBE SPRING ASSEMBLY: Install the air flow tube deep on the silencer duct until it contacts the projection on the silencer duct. [7] AIR FLOW TUBE CLAMP [9]-1 PROJECTION [8] VINYL TUBE 5-128 [1] HARNESS BAND CLIP 3] IAT SENSOR 2P [2] CONNECTOR AIR FLOW TUBE CLAMP