honda — Programmed Fuel Injection

BF135A•BF150A b.THROTTLE BODY/INTAKE MANIFOLD REMOVAL [1] MAP SENSOR 3P CONNECTOR 1) Remove the silencer case (P. 5-128). 2) Disconnect the MAP sensor 3P connector and remove the harness band clip. [2] HARNESS BAND CLIP 3) Remove the water level sensor connector from the the har- ness clip bracket E. [1] TP SENSOR 3P CONNECTOR [2] WATER LEVEL SENSOR CONNECTOR 4) Disconnect the TP sensor 3P connector and remove the harness band clip from the harness clip bracket E. [4] HARNESS BAND CLIP [3] HARNESS CLIP BRACKET E 5) Remove the throttle rod. Do not loosen the pivot lock nut. [1] THROTTLE ROD 6) Remove one 8 x 60 mm flange bolt and remove the throttle body. 7) Remove the throttle body gasket.

Replace the throttle body gasket with a new one. The intake manifold assembly can be removed by skip- ping the steps 6 and 7 (i.e. with the throttle body mount- ed). [2] THROTTLE BODY 8) Disconnect the IAB control valve 2P connector. [1] IAB CONTROL VALVE 2P CONNECTOR 5-129