honda — Programmed Fuel Injection

BF135A•BF150A [5] O-RING Do not reuse. [5] O-RING Do not reuse. e. INTAKE MANIFOLD INSTALLATION 1) Install the new intake manifold gasket on the intake manifold assembly. Install aligning the projection on the gasket with the groove in the intake manifold. 2) Install the intake manifold assembly on the engine. Take care not to pinch the pressure regulator return hose and the air vent tube at the top of the intake manifold. 5-132 d.THROTTLE BODY DISASSEMBLY/REASSEMBLY [1] MAP SENSOR ASSEMBLY: Apply the engine oil to the new O-ring and install it on the MAP [2] sensor. Install aligning the 5 x 18 mm SCREW cutout in the set plate with the lib of the sensor as shown.

[1]-1 MAP [3] SENSOR SET PLATE [1] MAP SENSOR ASSEMBLY: Apply the engine oil to the new O-ring and install it on the MAP sensor. Install aligning the cutout in the set plate with the lib of the sensor as shown. [1]-1 MAP SENSOR [3] SET PLATE [1]-2 SET PLATE [1]-1 MAP SENSOR [4] HARNESS CLIP BR ACKET E ASSEMBLY: Install the bracket aligning the cutout in the bracket with the stopper pin. [4]-1 HARNESS CLIP BRACKET E [4]-2 STOPPER PIN t aligning bracket n. ESS CLIP KET E [6] IDLE ADJU ADJUSTMEN T: P. 5-93 [2] INTAKE MANIFOLD [1] PROJECTION [6] GROOVE [5] TOP OF INTAKE MANIFOLD GASKET [3] AIR VENT TUBE [4] PRESSURE REGULATOR RETURN HOSE NT TUBE 4] RESSURE REGULATOR ETURN HOSE