BF135A•BF150A f. SILENCER CASE INSTALLATION [2] CRANKCASE BREATHER TUBE 1) Install the silencer case and tighten the three 6 x 25 mm flange bolts and the three 6 mm washers. Check that the wire harnesses are not pinched. Set the main harness in the groove in the left lower sec- tion of the silencer case. [1] SILENCER CASE 6 x 25 (3) 2) Tighten the three 6 x 25 mm flange bolts securely. 3) Connect the crankcase breather tube. [3] 6 mm WASHER (3) [5] WIRE HARNESS [4] SILENCER CASE 4) Fasten the air flow tube clamp securely. [1] HARNESS BAND CLIP 5) Connect the IAT sensor 2P connector and secure the har- ness band clip in the hole in the silencer case.
[3] IAT SENSOR 2P CONNECTOR [2] AIR FLOW TUBE CLAMP 5-135