BF135A•BF150A 13. FUEL INJECTOR/PRESSURE REGULATOR a. FUEL LINE ASSEMBLY REMOVAL Gasoline is highly flammable and explosive. You can be burned or seriously injured when handling fuel. Keep heat, sparks, and flame away. Handle fuel only outdoors. Wipe up spills immediately. [1] L. SIDE COVER BRACKET Relieve the fuel pressure before removing the fuel injectors. Disconnect the battery cable from the battery negative (–) terminal before relieving the fuel pressure. Replace the sealing washer with a new one when the ser- vice check bolt had been loosened or removed. 1) Remove the engine cover and the L. engine under cover.
2) Relieve the fuel pressure according to “HOW TO RELIEVE FUEL PRESSURE” (P. 5-102). 8 x 55 (2) 3) Remove the two 8 x 55 mm flange bolts and move the L. side cover bracket out of position. 4) Remove the three main harness clips from the respective clip brackets. [1] HOSE CLIP 5) Disconnect the connector from each injector. 6) Remove the hose clip. Clamp the pressure regulator return hose and the main wire harness. [2] CLIP [5] CLIP BRACKET [4] INJECTOR 2P CONNECTOR [3] MAIN WIRE HARNESS 5-136