BF135A•BF150A c. INJECTOR BASE REMOVAL/INSTALLATION 1) Remove the fuel injectors (P. 5-136). 2) Remove the silencer case (P. 5-128) and remove the intake manifold (P. 5-129). 3) Remove the five 8 x 25 mm flange bolts and the two 8 mm flange nuts, then remove the injector base and the injector base gasket. 4) Install the removed parts in the reverse order of removal. Replace the injector base gasket on assembly. Tighten the 8 x 25 mm flange bolts and the 8 mm flange nuts to the specified torque in the numbered sequence in a criss-cross pattern in two or three steps. TORQUE: 24 N m (2.4 kgf m, 18 lbf ft) [1] INJECTOR BASE GASKET Do not reuse.
[2] INJECTOR BASE [3] 8 mm FLANGE NUT (2) 24 N·m (2.4 kgf·m, 18 lbf·ft) 8 x 25 (5) 24 N·m (2.4 kgf·m, 18 lbf·ft) 5-139