BF135A•BF150A d. FUEL TUBE ASSEMBLY INSTALLATION 1) Apply the engine oil to the O-rings on the injectors. Install the fuel line assembly and tighten the 8 mm flange nuts securely. Replace the O-rings on assembly. [1] AIR VENT TUBE [2] STUD BOLT (2) 22 N·m (2.2 kgf·m, 16 lbf·ft) 2) Set the air vent tube (2 places) and the fuel tube (2 places) on the 14 mm fuel tube clip. [6] FUEL TUBE [5] FUEL LINE ASSEMBLY [4] 14 mm FUEL TUBE CLIP [3] 8 mm FLANGE NUT (2) 3) Apply the engine oil to the O-rings and install them on the joint pipe. 4) Install the joint pipe on the fuel line. 5) Install the pressure regulator and tighten the joint nut to the specified torque.
Install the pressure regulator in the direction shown. TORQUE: 27 N m (2.8 kgf m, 20 lbf ft) 6) Connect the pressure regulator return hose and secure it with the tube clamp D10.7. REGULATOR 7) Connect the pressure regulator control tube. 10 5-140 [1] [2] PRESSURE REGULATOR PRESSURE CONTROL TUBE REGULATOR RETURN HOSE [3] PRESSURE REGULATOR [6] TUBE CLAMP D10.7 [4] O-RING (2) D10.7 [4] O-RING (2 [5] Do not reuse JOINT PIPE [3] PRESSURE Do not reuse IPE [3] . PRESSURE