7) Remove the four 4 x 6 mm screws from the rectifier assembly. [1] WIRE (Straighten.) 8) Straighten the four wires as shown and remove the rectifier assembly. Replace the stator with a new one if a wire broke near the small hole in the rectifier assembly. NOTICE [2] 4 x 6 mm SCREW (4) [3] RECTIFIER ASSEMBLY 9) Remove the two 5 mm hex. nuts and the two rear housing bolts. Remove the rear housing. [1] 5 mm HEX. NUT (2) [2] REAR HOUSING BOLT (2) 10) Remove the wave washer. [3] REAR HOUSING [4] WAVE WASHER 6-11