11) Remove the rotor from the stator (drive end housing). [1] BEARING COVER Remove the bearing cover from the rotor shaft. [2] STATOR [DRIVE END HOUSING] [3] ROTOR 12) Check the rear bearing for abnormal sound and play before removal. Replace the rear bearing with a new one if there is abnormal sound or play. 13) Using a commercially available bearing puller as shown, remove the rear bearing and washer. Replace the rear bearing with new one on assembly. [1] BEARING PULLER (Commercially available) NOTICE Install a commercially available bearing puller with care not to damage the rotor fins. [2] REAR BEARING [3] WASHER [2] REAR BEARING 6-12