7) Check the rotor slip rings for contamination with grease. [1] BEARING COVER If it is contaminated with grease, wipe it off thoroughly with a clean cloth. Install the rotor on the stator [drive end housing]. Install a bearing cover on the rotor shaft. [2] SLIP RINGS [3] STATOR [DRIVE END HOUSING] [4] ROTOR 8) Apply grease to the surface of the rear bearing and install the wave washer. [1] HOLES (Four places) [2] REAR HOUSING BOLT (2) 9) Pass the wire through the respective four holes in the rear housing. Install the rear housing on the stator [drive end housing] and tighten the two 5 mm hex. nuts and the rear housing bolts securely. [3] 5 mm HEX.
NUT (2) Install the rear housing aligning the outer side of the wave washer with the outer side of the bearing. [4] REAR HOUSING [6] WAVE WASHER [5] WIRES 6-19