honda — Alternator

10) Pass the four wires through the four holes at the projection on the reverse side of the rectifier assembly. [1] WIRE (Bend along the hole.) 11) Bend each wire to the rectifier assembly side. Bend each wire along the respective screw holes. 12) Tighten the four 4 x 6 mm screws securely. NOTICE Replace the stator with a new one if a wire broke near the hole in the rectifier assembly. [2] 4 x 6 mm SCREW (4) [3] RECTIFIER ASSEMBLY 13) Assemble the brush holder insulator with the brush holder assembly. [1] BRUSH HOLDER INSULATOR 14) Position the brush holder assembly on the IC regulator and loosely tighten the 4 x 6 mm screw.

Loosely tighten the 4 x 6 mm screw so that the brush holder does not move. [2] 4 x 6 mm SCREW (Loosely tighten so the brush holder does not move.) [3] BRUSH HOLDER ASSEMBLY [4] IC REGULATOR 6-20