15) Tighten the two 4 x 25 mm screw-washers and the two 4 x 6 mm screws securely while pushing the brush of the IC regulator/brush holder assembly, assembled in step 14, lightly against the rotor shaft slip rings. [1] 4 x 6 mm SCREW (2) [2] 4 x 25 mm SCREW- WASHER (2) Tighten the 4 x 6 mm screw securely that has been tightened loosely in step 14. [3] IC REGULATOR/BRUSH HOLDER ASSEMBLY Take care not to damage the rotor shaft slip rings with the brush during installation. NOTICE [4] SLIP RINGS 16) Install the rear end cover and tighten the three rear end cover bolts securely. [1] REAR END COVER BOLT (3) 17) Install the insulator bushing and tighten the 6 mm hex. nut securely.
[2] REAR END COVER [3] INSULATOR BUSHING [4] 6 mm HEX. NUT 6-21