18) Position the alternator pulley on the rotor shaft and tighten the pulley lock nut. [1] ALTERNATOR PULLEY 19) Tighten the pulley lock nut to the specified torque using a 10 mm offset wrench and a torque wrench. [2] PULLEY LOCK NUT TORQUE: 110 N . m (11.2 kgf . m, 81 lbf . ft) [5] TORQUE WRENCH [3] PULLEY LOCK NUT i. ALTERNATOR BRACKET ASSEMBLY [4] 10 mm OFFSET WRENCH 1) Tighten the alternator bracket with the four 8 x 28 mm flange bolts securely. 2) Tighten the 6 x 16 mm flange bolt securely while pushing the alternator stay against the projection on the alternator bracket. 3) Position the special adjusting bolt on the tensioner bolt.
4) Install the engine hanger B with the two 8 x 20 mm flange bolts. 6-22 8 x 20 (2) [1] ENGINE HANGER B [2] ALTERNATO BRACKET [3] PROJECTION 8 x 28 (4) [5 [6] TENSIONER BOLT S B ] PECIAL ADJUSTING OLT