15) Install the chain case on the cylinder block aligning the end of the chain case at the crankcase side. 6 x 28 (10) [1] 6 x 38 (SH BOLT) 10 x 43 (3) 16) Loosely tighten the two 6 x 31 mm special bolts in the positions shown. [2] 6 x 31 mm SPECIAL BOLTS 17) Loosely tighten all the chain case bolts but the two 6 x 31 mm special bolts, and tighten them to the specified torque in two or three steps in a criss-cross pattern. (Tighten the three 10 x 43 mm flange bolts to the standard torque.) TORQUE: 6 x 38 mm (SH) flange bolt (1)/ 6 x 28 mm flange bolts (10)/ 6 x 31 mm special bolts (2)/ 6 x 25 mm flange bolts (3): 12 N . m (1.2 kgf . m, 9 lbf . ft) STANDARD TORQUE:
10 x 43 mm flange bolts (3): 39 N . m (40 kgf . m, 29 lbf . ft) NOTICE Do not touch the surfaces coated with the liquid gasket. [3] CHAIN CASE Take care not to slide the chain case during installation as it makes the thickness of the liquid gasket uneven. Take care not to let the chain case gasket and O-ring come out of position. 6 x 25 (3) [3] CHAIN CASE [4] CYLINDER BLOCK [5] CRANKCASE 9-16