• ROCKER ARM I.D. • ROCKER ARM-TO-ROCKER SHAFT CLEARANCE If the measurement exceeds the service limit, replace the rocker arm as an assembly and recheck. If the measurement still exceeds the service limit, replace the rocker shaft. [1] MID ROCKER ARM • VTEC ROCKER ARM ASEMBLY INSPECTION (BF150A only) Check of stuck rocker arm assembly at high lift side: 1) Remove the cylinder head cover (P. 10-2). 2) Put the No.1 piston at the top dead center of the compression stroke (P. 3-12). 3) Move the secondary rocker arm of the No.1 cylinder up and down with a finger. Check that the secondary rocker arm moves independent from the mid rocker arm.
NOTICE If it does not, remove and disassemble the rocker arm assembly to check (P. 10-18). If the rocker arm assembly is not normal, replace the rocker arm as an assembly. [2] SECONDARY ROCKER ARM 4) Repeat the step 2 and 3 on each cylinder to put the piston of each cylinder at the top dead center of its compression stroke. Check the secondary rocker arm. 5) Install the cylinder head cover (P. 10-40). Check of stuck rocker arm assembly at low lift side: NOTICE Before performing inspection with the special tool(s), check that the secondary rocker arm moves independently.
(See Check of stuck rocker arm assembly at high lift side.) Check with the special tool(s) can be made on the following conditions. At cylinder head disassembly Engine power drops significantly at high rpm but the cause of the problem cannot be identified by following the troubleshooting chart. 1) Start the engine and let it warm up for five minutes. 2) Remove the cylinder head cover (P. 10-2). 3) Check the valve clearance (P. 3-9). 10-16 STANDARD SERVICE LIMIT IN 17.019 – 17.035 mm (0.6700 – 0.6707 in) EX 17.012 – 17.039 mm (0.6698 – 0.6708 in) STANDARD SERVICE LIMIT IN 0.025 – 0.052 mm (0.0010 – 0.0020 in) 0.08 mm (0.003 in) EX 0.018 – 0.056 mm (0.0007 – 0.0022 in) 0.08 mm (0.003 in)