Check that the following conditions are met before using the air supply (special tool). The following conditions are essential for use of the air supply, as the specified air pressure of 290 kPa (3.0 kgf/cm 2 , 43 psi) must be maintained at the gauge of the tool. Stop using the other air tools unless the specified air pressure is maintained. Check whether the air compressor tank is under the specified air pressure and the tank gauge shows the value of the set pressure. Connect the air supply to the air intake port located close to the compressor.
Check as quickly as possible (within 6 seconds), or the air pressure drops possibly marking it hard to switch the valve timing to the high lift side. Check on each cylinder with the piston at the top dead center of its compression stroke. Oil can spurt out when the air pressure is applied. Adjust the air pressure with the regulator valve (special tool) and increase the air pressure gradually. NOTICE [1] AIR SUPPLY 07LAJ-PR30102 [2] AIR JOINT ADAPTER 07ZAJ-PNA0300 4) Remove the 10 mm sealing bolt from the No.1 camshaft holder and install the air stopper (special tool). 5) Remove the two mounting bolts of the No.2 and No.3 camshaft holders (intake side), and install the special tool as shown.
TOOLS: Air supply 07LAJ-PR30102 VTEC air adapter 07ZAJ-PNA0101 VTEC air stopper 07ZAJ-PNA0200 Air joint adapter 07ZAJ-PNA0300 [3] 10 mmSEALING BOLT NOTICE Install the VTEC air adapter (special tool) and tighten it by hand. [5] VTEC AIR ADAPTR 07ZAJ-PNA0101 6) Apply the specified air pressure and check that the valve timing switched to the high lift side. [4] VTEC AIR STOPPER 07ZAJ-PNA0200 Air pressure: 290 kPa (3.0 kgf/cm 2 , 43 psi) 7) Check that the three intake rocker arms are interconnected by applying the specified amount of air pressure. Move the secondary rocker arm up and down with a finger and check that both the mid rocker arm and the primary rocker arm move up and down, too.
8) If there is abnormality in the rocker arm movement, replace the intake rocker arm as an assembly. 9) Remove the VTEC air adapter (special tool) and tighten the camshaft holder mounting bolts to the specified torque. [2] MID ROCKER ARM [1] PRIMARY ROCKER ARM TORQUE: 22 N . m (2.2 kgf . m, 16 lbf . ft) 10) Remove the air stopper (special tool) from the No.1 camshaft holder, and tighten the 10 mm sealing bolt to the specified torque. TORQUE: 20 N . m (2.0 kgf . m, 14 lbf . ft) [3] SECONDARY ROCKER ARM 11) Install the cylinder head cover (P. 10-40). 12) Check that the MIL does not come ON. 10-17