honda — Cylinder Heads/Valves

• VTEC ROCKER ARM/ROCKER ARM INSPECTION 1) Disassemble the rocker arm assembly. Check that the rocker arm pistons move smoothly. BF150A: [1] ROCKER ARM PISTONS Remove the pistons from the primary rocker arm by applying low air pressure to the rocker arm. Take care not to apply excessive air pressure as the pistons can jump out of the rocker arm. After removing the rocker arm assembly, tie the assembly with a rubber band or equivalent to prevent each component of the assembly from missing. Note to remove the rubber band after installation. NOTICE 2) If the pistons do not move smoothly, replace the rocker arm as an assembly. BF135A:

[1] ROCKER ARM PISTONS 3) Apply the engine oil to the rocker arm pistons on assembly. 10-18