honda — Cylinder Heads/Valves

5. CYLINDER HEAD ASSEMBLY REMOVAL Removal of the cylinder head assembly must be made when the engine is cold (38˚C or below). Take care not to damage (scores or scratches) the gasket mating surfaces with the cylinder head and the cylinder block. Do not bend the cylinder head gaskets as they are the metal gaskets. Keep the cam chain away from the magnetic parts. NOTICE ① ② ⑤ ⑥ Remove the following pars. – Engine cover (P. 4-2) – L./R. engine under covers (P. 4-9) – Ignition coil/spark plug (P. 3-6) – L./R. side cover brackets (P. 4-24) – Cylinder head cover (P. 10-2) 1) Move the remote control lever to the “N” (Neutral) position.

2) Turn the crankshaft pulley clockwise until it puts the No.1 piston at the top dead center of its compression stroke (P. 3-12). Remove the following pars. – Crankshaft pulley/cam chain (P. 9-2) – Camshaft/rocker arm (P. 10-5) – Throttle body/intake manifold (P. 5-129) – Fuel line assembly (P. 5-136) – Injector base (P. 5-139) – Exhaust manifold (P. 5-152) 3) Loosen the 11 x 155 mm bolt washers in the numbered sequence shown in two or three steps. 4) Remove the ten 11 x 155 mm bolt washers from the cylinder head assembly. ⑨ ⑩ ⑦ ⑧ ③ ④ [1] CYLINDER HEAD GASKET 5) Remove the cylinder head assembly. Remove the cylinder head gasket and the two dowel pins.

Replace the cylinder head gasket with a new one on assembly. [2] 14 x 20 mm DOWEL PIN (2) [3] CYLINDER HEAD ASSEMBLY 10-19