4) Install the valve spring and the valve spring retainer. NOTICE [1] VALVE SPRING Do not confuse the intake valve spring and the exhaust valve spring. The intake side can be identified with the pink paint on the spring. The exhaust side can be identified with the gray paint. Install the intake and the exhaust valve springs with the paint mark side toward the valve spring retainer. [2] VALVE SPRING RETAINER [1] LOCATION OF VALVE SPRING PAINT: [2] PAINT [1] VALVE SPRING COMPRESSOR ATTACHMENT 07757-PJ10100 5) Using the same special tool as that used during disassembly, compress the valve springs and set the valve keepers in the groove in the respective valve stems securely. TOOLS:
Valve spring compressor 07757-0010000 Valve spring compressor attachment 07757-PJ10100 [3] VALVE KEEPER (2) [2] VALVE SPRING COMPRESSOR 07757-0010000 Take care not to let the special tools contact the cylinder head. Do not compress the valve springs more than necessary as it causes weak valve spring. The valve keepers can be installed in the groove in the valve stem by applying a small mount of grease to the valve keepers and adhering them to the groove in the valve stem. NOTICE 6) Tap on the valve stem head lightly with a plastic hammer two or three times and set the valve stem and keepers in the proper position securely. [1] PLASTIC HAMMER Tap at right angles with each valve stem head.
Take care not to bend the valve. Support the cylinder head with a suitable material to prevent damage to the valve. NOTICE 10-31