BF135A•BF150A No Perform the following checks and repair or replace as nec- essary. Clogged oil strainer Clogged oil filter Faulty oil pump Clogged oil passage Yes Oil pressure switch is faulty. • OIL PRESSURE INSPECTION 1) Remove the switch cover. Remove the 4 mm screw and the oil pressure switch wire. 2) Remove the oil pressure switch. 3) Install the oil pressure gauge attachment as shown. TORQUE: 8 N m (0.8 kgf m, 5.8 lbf ft) OIL PRESSURE GAUGE SET 07506-3000001 4) Install the oil pressure gauge set. 5) Start the engine and measure the oil pressure.
Oil pressure 0.147 MPa (1.5 kgf/cm 2 , 21.3 psi) at 2,050 min -1 (rpm) 6) Clean the threads of the switch and apply the liquid gasket (Three Bond 1215 or equivalent) to the indicated area. Install the oil pressure switch to the specified torque. TORQUE: 8.3 N m (0.85 kgf m, 6.1 lbf ft) OIL PRES- SURE GAUGE ATTACHMENT 07406-0030000 2-35 From P. 2-34 Check the oil pressure. Is the oil pressure within the specification? Y es Replace the oil pressure switch and start the engine. Do the oil indictor light come ON and the buzzer stop sounding? N o Substitute a known-good ECM and recheck. LIQ GA AP AR UID SKET PLICATION EA