• CRANKSHAFT AXIAL CLEARANCE Install the dial indicator as shown. Measure the crankshaft axial play by moving the crankshaft back and forth with a screwdriver. If the measurement exceeds the service limit, check the thrust washer and the cylinder block thrust surface. Replace the thrust washer and recheck. If the measurement still exceeds the service limit, replace the crankshaft. • THRUST METAL SIDE CLEARANCE Measure the clearance between the No.4 main journal thrust washer and the crankshaft. If the measurement exceeds the service limit, check the thrust washer and the cylinder block thrust surface. Replace the thrust washer and recheck.
If the measurement still exceeds the service limit, replace the crankshaft. • CRANKSHAFT RUNOUT 1) Install the No.1 and No.5 upper main bearings on the cylinder block. [2] NO.5 UPPER MAIN BEARING [1] CRANKSHAFT 2) Install the crankshaft on the cylinder block. 3) Set the dial indicator on the crankshaft. Measure the crankshaft runout by turning the crankshaft. [3] CYLINDER BLOCK 4) If the measurement exceeds the service limit, replace the crankshaft. [4] NO.1 UPPER MAIN BEARING 13-12 STANDARD SERVICE LIMIT 0.10 – 0.35 mm (0.004 – 0.014 in) 0.45 mm (0.018 in) STANDARD SERVICE LIMIT 0.10 – 0.35 mm (0.004 – 0.014 in) 0.45 mm (0.018 in) STANDARD SERVICE LIMIT 0.03 mm (0.001 in) Max.
0.04 mm (0.002 in)