• CYLINDER HEAD SURFACE WARPAGE 1) Take care not to damage (score, scratches, etc.) the mating surface with the gasket. 2) Measure the surface warpage using a straight edge and a feeler gauge as shown. • CONNECTING ROD BEARING OIL CLEARANCE 1) Clean the crank pin and the connecting rod bearing. Check the crank pin and the bearing for damage and wear. 2) Install the crankshaft on the cylinder block. Install the connecting rod cap on the connecting rod and tighten the connecting rod bolts to the specified torque (P. 13-22). 3) Remove the connecting rod cap. Set a plastigauge on the crank pin. [1] PLASTIGAUGE Set the plastigauge in the axial direction.
Tighten the connecting rod bolts with care not to turn the crankshaft and connecting rod. NOTICE 4) Reinstall the connecting rod cap and tighten the connecting rod bolts to the specified torque (P. 13-22). 5) Remove the connecting rod cap. Measure the pressured width of the plastigauge using the scale printed on the bag of the plastigauge. NOTICE [1] PLASTIGAUGE Measure the widest width on the plastigauge. 6) If the measurement exceeds the service limit, check the connecting rod big end I.D. and the crank pin O.D. If they are OK, replace with the undersize bearing by referring to the connecting rod bearing selection table (P. 13-16), and measure the oil clearance again.
[2] SCALE 13-13 STANDARD SERVICE LIMIT 0.07 mm (0.003 in) Max. 0.10 mm (0.004 in) STANDARD SERVICE LIMIT 0.032 – 0.066 mm (0.0013 – 0.0026 in) 0.077 mm (0.0030 in)