honda — Cylinder Block/Crankshaft/Pistons

• CRANKSHAFT MAIN BEARING OIL CLEARANCE 1) Clean the crankshaft main journals and the main bearings. Check the journals and the bearings for damage and wear. 2) Install the upper main bearings and the crankshaft on the cylinder block. Install the lower main bearings and the lower block and tighten the bolts to the specified torque (P. 13-24). 3) Remove the lower block and the lower main bearings. Set the plastigauge on each main journal of the crankshaft as shown. [1] PLASTIGAUGE NOTICE Set the plastgauges in the axial direction. Do not turn the crankshaft during this check. 4) Reinstall the lower main bearings and the lower block. Tighten the bolts to the specified torque (P. 13-24).

[1] PLASTIGAUGE 5) Remove the lower block and the lower main bearings. Measure the pressured width of the plastigauge using the scale printed on the bag of the plastigauge. Measure the widest width on the plastigauge. NOTICE [2] SCALE 6) If the measurement exceeds the service limit, check the lower block and the cylinder block main bearing I.D. and the crankshaft main journal O.D. If they are OK, replace with the undersize bearing by referring to the connecting rod bearing selection table (P. 13-18), and measure the oil clearance again. • CONNECTING ROD BOLT 1) Measure the O.D. of each connecting rod bolt at two points as shown, and calculate the gap between the measurements.

35 mm (1.4 in) 2) If the gap exceeds the standard value, replace the connecting rod bolt. 20 mm (0.8 in) NOTICE Measure the O.D. on each of the connecting rod bolt. 13-14 STANDARD SERVICE LIMIT No.1, 2, 4, 5 0.017 – 0.041 mm (0.0007 – 0.0016 in) 0.05 mm (0.002 in) No.3 0.025 – 0.049 mm (0.0010 – 0.0019 in) 0.055 mm (0.0022 in) STANDARD 0 – 0.1 mm (0 – 0.004 in)