honda — Cylinder Block/Crankshaft/Pistons

3. BEARING SELECTION a. CONNECTING ROD BEARING NOTICE When replacing the connecting rod bearing, check the crank pin code letter and the connecting rod code number, and select the correct bearing by referring to the bearing selection table. If the code letters and/or numbers are not clear, clean the areas with a cleaning solvent and check again. Do not scrub with a stiff brush or driver to clean. 1) Check the connecting rod code numbers and record them. NOTICE The connecting rod code numbers are for the No.1 and the subsequent number journals when viewed from the crankshaft pulley side. Connecting rod big end I.D.:

51 mm (2.0 in) [1] CONNECTING ROD CODE NUMBER 2) Check the crank pin code letters and record them. NOTICE [1] CRANK PIN CODE LETTER The crank pin code letters are for the No.1 and the subsequent number journals when viewed from the right side of the position shown or from the crankshaft pulley side. 3) Select the correct bearing by referring to the crank pin code letter and the connecting rod code number. [2] No.1 [3] No.2 [4] No.3 [5] No.4 [1] CRANK PIN CODE LETTER [5] No.4 [2] No.1 13-15 Code No.

Tolerance 1 or l ±0.000 – +0.006 mm (±0.0000 – +0.0002 in) 2 or ll +0.006 – +0.012 mm (+0.0002 – +0.0005 in) 3 or lll +0.012 – +0.018 mm (+0.0005 – +0.0007 in) 4 or llll +0.018 – +0.024 mm (+0.0007 – +0.0009 in)