Connecting rod bearing selection table: Selection table: Connecting rod bearing center thickness: 1.5 mm (0.06 in) The connecting rod bearings are available in blue, black, brown, green, yellow, pink and red of the size identification color in this order in increments of 0.003 mm (0.0001 in). 4) Note that the oil clearance is set taking the enlarged amount of the housing caused by crash into consideration. The bearings are selected so that the oil clearance is 0.032 – 0.066 mm (0.0013 – 0.0026 in). 5) Check the oil clearance after installing the selected bearing (P. 13-13).
6) Align the projection on the bearing with the cutout in the connecting rod or cap, and install with care not to damage the sliding surface. [1] PROJECTION [2] IDENTIFICATION COLOR Do not determine the bearing simply by referring to the selection table, but check the oil clearance. If the selection table shows two identification colors, use a pair of the bearing of each color for the upper and lower bearings. NOTICE 13-16 Crank pin code letter Connecting rod code number 1 or l 2 or ll 3 or lll 4 or llll Bearing identification color A Red Pink Pink/ Yellow Yellow B Pink Yellow Yellow/ Green Green C Yellow Green Green/ Brown Brown D Green Brown Brown/ Black Black Mark I.D.
color Tolerance G Red –0.008 – –0.005 mm (–0.0003 – –0.0002 in) F Pink –0.005 – –0.002 mm (–0.0002 – –0.0001 in) E Yellow –0.002 – +0.001 mm (–0.0001 – +0.00004 in) D Green +0.001 – +0.004 mm (+0.00004 – +0.0002 in) C Brown +0.004 – +0.007 mm (+0.0002 – +0.0003 in) B Black +0.007 – +0.010 mm (+0.0003 – +0.0004 in) A Blue +0.010 – +0.013 mm (+0.0004 – +0.0005 in)