b. CRANKSHAFT MAIN BEARING When replacing the main bearing, check the crankshaft main journal code number and the cylinder block I.D. code letter or number, and select the correct bearing by referring to the bearing selection table. If the code letter and/or number is not clear, clean the area with a cleaning solvent and check again. Do not scrub with a stiff wire brush or driver to clean. NOTICE 1) Check the cylinder block I.D. code letters or numbers and record them. NOTICE The cylinder block I.D. code letters or numbers are for the No.1 and the subsequent number journals when viewed from the left side. [1] CYLINDER BLOCK I.D. CODE LETTER OR NUMBER Cylinder block I.D.:
59 mm (2.3 in) [2] NO.1 MAIN JOURNAL [3] NO.5 MAIN JOURNAL 2) Check the crankshaft main journal code numbers and record them. [1] CRANKSHAFT MAIN JOURNAL CODE NUMBER The crankshaft main journal code numbers are for the No.1 and the subsequent number journals when viewed from the right side of the position shown or from the crankshaft pulley side. NOTICE 3) Select the correct bearing by referring to the cylinder block I.D. code letter or number and the crankshaft main journal code number. [2] No.1 [3] No.2 [4] No.3 [5] No.4 [6] No.5 [1] CRANKSHAFT MAIN JOURNAL CODE NUMBER [6] No.5 [2] No.1 13-17 Code No.
Tolerance 1 or A or l ±0.000 – +0.006 mm (±0.0000 – +0.0002 in) 2 or B or ll +0.006 – +0.012 mm (+0.0002 – +0.0005 in) 3 or C or lll +0.012 – +0.018 mm (+0.0005 – +0.0007 in) 4 or D or llll +0.018 – +0.024 mm (+0.0007 – +0.0009 in)