Crankshaft main bearing selection table: Selection table: Main bearing center thickness: 2.0 mm (0.08 in) The main bearings are available in blue, black, brown, green, yellow and pink of the size identification color in this order in increments of 0.003 mm (0.0001 in). 4) Note that the oil clearance is set taking the enlarged amount of the housing caused by crash into consideration. The bearings are selected so that the oil clearance for the No.1, 2, 4 and 5 journals is in the range of 0.017 – 0.041 mm (0.0007 – 0.0016 in), and the oil clearance for the No.3 journal is in the range of 0.025 – 0.049 mm (0.0010 – 0.0019 in).
[1] PROJECTION [2] IDENTIFICATION COLOR 5) Check the oil clearance after installing the selected bearing (P. 13-14). 6) Align the projection of the bearing with the cutout in the cylinder block or lower block, and install with care not to damage the sliding surface. NOTICE Do not determine the bearing simply by referring to the selection table, but check the oil clearance. If the selection table shows two identification colors, use a pair of the bearing of each color for the upper and lower bearings. 13-18 Crankshaft main journal code number Cylinder block I.D.
code letter or number 1 or A or l 2 or B or ll 3 or C or lll 4 or D or llll Bearing identification color 1 Pink Pink/ Yellow Yellow Green 2 Pink/ Yellow Yellow Green Green/ Brown 3 Yellow Green Green/ Brown Brown 4 Green Green/ Brown Brown Black 5 Green/ Brown Brown Black Black/ Blue 6 Brown Black Black/ Blue Blue Mark I.D. color Tolerance F Pink –0.006 – –0.003 mm (–0.0002 – –0.0001 in) E Yellow –0.003 – ±0.000 mm (–0.0001 – ±0.0000 in) D Green ±0.000 – +0.003 mm (±0.0000 – +0.0001 in) C Brown +0.003 – +0.006 mm (+0.0001 – +0.0002 in) B Black +0.006 – +0.009 mm (+0.0002 – +0.0004 in) A Blue +0.009 – +0.012 mm (+0.0004 – +0.0005 in)