honda — Cylinder Block/Crankshaft/Pistons

4. ASSEMBLY a. PISTON ASSEMBLY 1) Install the piston pin clip only on one side of the piston. Take care not to let the piston pin clip jump out of position. NOTICE [1] PISTON PIN CLIP 2) Warm up the piston to approximately 70˚C (158˚F). CAUTION Take care not to get your hand, etc. burned during assembly. 3) Apply molybdenum disulfide oil to the outer surface of the piston pin, inner wall of the piston pin hole in the piston and to the inner wall of the connecting rod small end. Install the connecting rod on the piston and install the piston pin. [1] ” MARK NOTICE Install the piston pin so that the “ ” mark on the piston head points to the model mark on the connecting rod.

[2] MODEL MARK 4) Install the piston pin clip on the opposite side from where the piston pin clip was installed in step 3. NOTICE [3] MOLYBDENUM DISULFIDE OIL [4] PISTON PIN Take care not to let the piston pin clip jump out of position. [5] PISTON PIN CLIP 5) Install the connecting rod bearing on the connecting rod by aligning the projection on the bearing with the concave in the connecting rod. [7] CONNECTING ROD 13-19 [6] CONNECTING ROD BEARING [8] PIS TON