honda — Cylinder Block/Crankshaft/Pistons

b. LOWER BLOCK/CRANKSHAFT/CYLINDER BLOCK 1) Apply molybdenum disulfide oil to the piston skirt and the inner wall of the cylinder sleeve. 2) Using the handle of a hammer, drive the piston slowly into the cylinder block with the “ ” mark on the piston toward the cam chain side. [1] ” MARK [2] MOLYBDENUM DISULFIDE OIL [3] PISTON RING COMPRESSOR (Commercially available) [2] MOLYBDENUM DISULFIDE OIL 3) Apply engine oil to the threads and seat of the oil jet bolts. 4) Install the oil jet body on each of the No.1 and No.2 cylinder and tighten the oil jet bolts to the specified torque. [1] OIL JET BOLT TORQUE: 16 N . m (1.6 kgf . m, 12 lbf .

ft) [2] OIL JET BODY 5) Apply engine oil to the new 6.5 x 1.5 mm O-ring and install it on the oil jet orifice. Install the oil jet orifice on the cylinder block. [1] CYLINDER BLOCK [2] 6.5 x 1.5 mm O-RING [3] OIL JET ORIFICE 13-21