6) Install the upper main bearings on the cylinder block aligning the projection on the upper main bearing with the concave in the cylinder block. [1] PROJECTION [2] UPPER MAIN BEARING 7) Apply molybdenum disulfide oil to the crankshaft main journal, crank pin and the thrust washer mating surfaces. 8) Put the No.2 and No.3 pistons at the bottom dead center of their stroke. Install the crankshaft on the cylinder block while aligning it with the No.2 and No.3 connecting rods. NOTICE [3] CONCAVE Install the crankshaft with care not to damage the journals.
[4] MOLYBDENUM DISULFIDE OIL [5] CRANKSHAFT [7] CYLINDER BLOCK [6] UPPER MAIN BEARING (5) 9) Install the connecting rod bearing on the connecting rod cap aligning the projection on the connecting rod bearing with the concave in the connecting rod cap. [1] CONNECTING ROD BEARING [2] 10 x 12 mm DOWEL PIN (2) 10) Install the two dowel pins on the connecting rod cap. [3] CONNECTING ROD CAP 13-22