honda — Cylinder Block/Crankshaft/Pistons

11) Apply engine oil to the threads and seat of the connecting rod bolts. Install the connecting rod cap assembly on the connecting rod and tighten the two connecting rod bolts to the specified torque. After tightening to the specified torque, tighten the bolts to an additional 90˚. [1] CONNECTING ROD CAP ASSEMBLY [2] CONNECTING ROD BOLT (2) TORQUE: 20 N . m (2.0 kgf . m) + 90˚ NOTICE Install the connecting rod cap assembly aligning the code number with the number on the counter part. Check that the piston is at the bottom dead center of its stroke before tightening the bolts. It not, turn the crankshaft to bring the piston at the bottom dead center.

[3] CODE NUMBER 12) Apply engine oil to the thrust washers and install them on the cylinder block No.4 journal. [1] THRUST WASHER (2) NOTICE Install the thrust washers with the grooved side toward the crankshaft. [2] GROOVES 13) Install the lower main bearings on the cylinder block aligning the projection on the lower main bearing with the concave in the lower block. [1] LOWER BLOCK ORIFICE 14) Apply engine oil to the threads of the lower block orifice. Tighten the lower block orifice on the lower block to the specified torque. TORQUE: 10 N . m (1.0 kgf . m, 7 lbf . ft) [2] LOWER BLOCK [3] LOWER MAIN BEARING (5) 13-23