7) Position the propeller shaft holder assembly on the fixing tool and secure the holder assembly with the bolt. 8) Hold the fixing tool with a vise. [1] PIN SPANNER WRENCH, 110 mm 07WAA-S1G0100 9) Loosen the bearing holder using the special tool as shown. TOOL: Pin spanner wrench, 110 mm 07WAA-S1G0100 10) Remove the bearing holder assembly from the propeller shaft holder. Avoid holding the propeller shaft holder directly in a vise. Use the fixing tool to hold it in a vise. NOTICE [2] PROPELLER SHAFT HOLDER ASSEMBLY [3] FIXING TOOL 11) Before removing the taper bearing (inner race), check the inner race for abnormal sound and play.
If there is any abnormal sound or play in the inner race, replace the inner race and the outer race as a set. [1] DRIVER 07749-0010000 12) Attach a commercially available universal bearing puller between the bearing holder and the forward bevel gear. 13) Remove the forward bevel gear from the taper bearing (inner race) using the special tools and the hydraulic press. [7] 50 x 90 x 28 mm TAPER BEARING (INNER RACE) [2] ATTACHMENT, 27.2 07747-0010300 TOOLS: Driver 07749-0010000 Attachment, 27.2 07747-0010300 Pilot, 35 mm 07746-0040800 [3] UNIVERSAL BEARING PULLER (Commercially available) [6] BEARING HOLDER [5] FORWARD BEVEL GEAR [4] PILOT, 35 mm 07746-0040800 14-59