honda — Propellor/Gear Case/Extension Case/Oil Case

14) Before removing the taper bearing (outer race), check the outer race for damage. Replace the inner race and the outer race as a set if necessary. [1] TAPER BEARING DRIVER ATTACHMENT 070PD-ZY60100 [2] DRIVER 07749-0010000 15) Remove the taper bearing (outer race) from the bearing holder using the special tools and the hydraulic press. TOOLS: Driver 07749-0010000 Taper vearing driver attachment 070PD-ZY60100 [3] BEARING HOLDER 16) Remove the shim from the bearing holder. Replace the shim with a new one on assembly. 17) Remove the thrust bearing washer and the propeller shaft from the propeller shaft holder.

[1] PROPELLER SHAFT HOLDER [2] THRUST BEARING WASHER [3] PROPELLER SHAFT 18) Check the thrust bearing for abnormal sound and play. Replace if necessary. [2] THRUST BEARING WASHER [1] PROPELLER SHAFT HOLDER 19) Remove the thrust bearing, thrust bearing washer, shim and the 105 x 3.1 mm O-ring from the propeller shaft holder. NOTICE [3] THRUST BEARING [4] THRUST SHIM Replace the shim with a new one on assembly. Replace the 105 x 3.1 mm O-ring with a new one on assembly. [5] 105 x 3.1 mm O-RING 20) Before removing the 30 x 45 x 7 mm water seals, check the water seal lips for cut and replace if necessary.

[1] 30 x 45 x 7 mm WATER SEALS 21) Remove the two 30 x 45 x 7 mm water seals from the propeller shaft holder using a commercially available oil seal remover. Replace the water seals with the new ones on assembly. [2] PROPELLER SHAFT HOLDER 14-60