e. ASSEMBLY OF SHIFT LINK BRACKET ASSEMBLY 1) Apply marine grease to the outer surface of the two bushing As and the inner wall at the mounting part of the bushing A in the link bracket. Install the two bushing As in the shift link bracket. 2) Apply marine grease to the outer surface of the throttle plate shaft. Install the throttle plate on the shift link bracket. Set the 8 mm washer on the throttle plate, and set the 6 mm E-ring in the groove in the throttle plate securely. 3) Apply marine grease to the outer surface of the throttle arm link pin. Set the link pin on the throttle arm and secure with the pivot washer and the 4 mm E-ring.
4) Apply marine grease to the inner wall at the mounting part of the shift link bracket in the throttle arm. Apply marine grease to the throttle arm mating surfaces on the shift link bracket, and install the throttle arm on the shift link bracket. 5) Apply marine grease to the 6 mm washer and the throttle arm mating surfaces. Set the 6 mm washer on the throttle arm and tighten the 6 x 12 mm flange bolt securely. 6) Apply marine grease to the mounting part of the throttle arm and the mounting part of the throttle plate in the throttle link, then install the throttle link. 7) Apply marine grease to the shift slide pivot and the outer surface of the shift link pin.
Apply marine grease to the entire surface of the link pin. Apply marine grease to the chamfered side of the shift pivot plate. 8) Set the shift link pin and the link pin on the shift slide pivot. Install the shift slide pivot on the shift link bracket. 9) Install the shift pivot plate with its chamfer toward the shift link bracket. Set the 4 mm E-rings in the grooves in the shift link pin and the link pin securely.
[4] THROTTLE PLATE [1] THROTTLE LINK [2] (MARINE GREASE) [3] LINK PIN [5] BUSHING A (2) [18] THROTTLE ARM [2] (MARINE GREASE) [17] 6 mm WASHER [2] (MARINE GREASE) [6] SHIFT LINK BRACKET [16] (Apply marine grease to the reverse side of the washer.) 6 x 12 [2] (MARINE GREASE) [2] (MARINE GREASE) [7] 8 mm WASHER [15] PIVOT WASHER [14] 4 mm E-RING (3) [8] 6 mm E-RING [9] SHIFT PIVOT PLATE [13] CHAMFER [12] SHIFT LINK PIN [2] (MARINE GREASE) [11] LINK PIN [10] SHIFT SLIDE PIVOT [2] (MARINE GREASE) 17-16