f. INSTALLATION 6 x 12 1) Apply marine grease to the inner wall of a new detent arm bushing. Set the detent arm bushing on the detent arm. 2) Apply marine grease to the seal holder shaft. Apply marine grease to the roller area of the detent arm. [1] 6 mm WASHER [2] CONCAVE 3) Align the hook (A) of the detent spring with the concave in the detent arm as shown. Align the other hook (B) with the seal holder hole and install the detent spring. [9] DETENT ARM [8] DETENT ARM BUSHING 4) Set the 6 mm washer on the detent arm and tighten the 6 x 12 mm flange bolt securely.
[7] HOOK (A) [3] (MARINE GREASE) [6] HOOK (B) [4] DETENT SPRING [5] HOLE [3] (MARINE GREASE) 5) Set the neutral switch on the neutral switch bracket and tighten the 20 mm hex. nut to the specified torque. TORQUE: 2.5 N . m (0.25 kgf . m, 1.8 lbf . ft) [2] NEUTRAL SWITCH BRACKET [1] 20 mm HEX. NUT [3] NEUTRAL SWITCH 17-17